[DM-MUG] Replacing drive in MacPro early 2008

[Victoria L. Herring]

Thanks = I found the number - no RAID setup.  In Bay 2 was a drive 
that I needed to take out = so I got a new drive [Hitachi 1TB SATA 
etc] and using my WiebeTech enclosure and Disk Utility Initialized it 
and set it up as usual.  I had copied over data off old Bay2 to the 
new one and checked and data was fine on it - Then took out old Bay2 
and put in new Bay 2 and restarted computer  - on restart the 
computer would not recognize the new Bay2 -- I told it to Ignore = 
but what now?  Why doesn't my MacPro recognized the newBay2 which was 
created with DiskUtility, fresh and ready to go and the data was fine 
when it was in the WiebeTech.?

Before I just initialize and start over are there any other ideas == 
other than this drive that won't mount or be recognized the computer 
works just fine.
-- 
Victoria L. Herring, Des Moines, Iowa. Blogs: 
http://blog.JourneyZing.com  [photography]; 
http://www.herringlaw.com  [civilrights/discrimination]; 
http://victorialherring.typepad.com/serendipity/  [personal].